SteamShield on Shapeways

SteamShield @shadowchaos5150 sure just did that. Also sorry I must raise the price by 13 cents because shapeways had really been eating away what we can make.

SteamShield @thrashc12 No this head is slightly too small for the siege figure and the joint is the wrong size

SteamShield @chandlerbentley18 hi it will. However you need to remove a lot of the original shoulder to fit this set.

SteamShield @arsnof I only have a g1 style if you are interested...

SteamShield @Awsomedude Tamiya NATO green spray paint

SteamShield @spena1984 Hi, sorry it is impossible to take apart legends groove without destroying the figure - something I don't want to do. If you have measurements of the neck (I think it is a mushroom peg) I can definitely do the resize accordingly)

SteamShield @underscorex From what I see, (MJF) PA12 has strength advantage but not so much from finish standpoint. This model is not an application that requires the added z-axis strength.

SteamShield @HarleyQuinade Just released a slightly larger model designed for the siege mold.

SteamShield @HarleyQuinade I am not sure, if they both use 5mm ball joint then yes.

SteamShield @deceptibass there are a couple of very nicely done slipstream heads on shapeway already I beleive.

SteamShield @HarleyQuinade no it wouldn't unless you do some DIY

SteamShield @rlmiddleton I don't know, sorry

SteamShield I finally got around and updated the model so that it is a tad (~0.5mm) smaller in all directions. Should now fit the body better.

SteamShield @estanima Looking great! Thanks for sharing!

SteamShield @xXX_Nightstrike_XXx great! There's also a replacement chest plate to match.

SteamShield @AsherV20 if Wing Saber has the common hexagonal connector then yes.

SteamShield @guinja Thanks for sharing!

SteamShield @HarleyQuinade no I just created an alternate version that does, https://www.shapeways.com/product/LPJABQVNA/kissy-medic-s-head-with-5mm-ball-joint-socket

SteamShield @ApeFace Yes

SteamShield @dwadamson97 yes. The plastic is not as transparent as the original but will let light come through

SteamShield @Measa_78 Sorry to hear what happened. The ball joint socket of this figure has a 3.6mm diameter. That's based on the measurement of POTP Jazz figure, but not the others. Did you try this on Jazz?