Activity

nathanblyth300 Hi, Any chance I can just purchase a listing of the Timing cover and Waterpump from this 1/8th scale engine unit? (I will subsequently promote you as the source on the forum it's potential use for the Deagostini 1/8 Ford Mustang 428 replacement if successful along with some of your other components)

nathanblyth300 Hi Ron, Any chance these could be resized for 1/8th scale and listed? If so please give me a heads up as will purchase accordingly

nathanblyth300 Hi, I'm seeking a set of these that would conform to the opening size of the Paragrafix photo etch floor. Their floor panel/opening width is 35x35mm. Are you able to scale and produce this maintenance pit set for that 35mm size opening?

nathanblyth300 @TonyRR Yes please & Roger that - I dont mid doing the plastic surgery to adapt it - I was going to decimate the Deago and scratch build it with plastic card had I not found this offering. So Thanks in advance!

nathanblyth300 Could this possibly be rescaled to 1/43 and produced as a replacement piece for the rather bare 1/43 DeAgo turret?

nathanblyth300 Wish i saw this messages/comments below before ordering. The size received is far to big. the 55mm needs width to be about 35mm or reduced to 70% of current production size to fit 1/43 Deagostini/Paragrafix photoetch floor set. Is this doable given the details?

nathanblyth300 Hi, roughly what scale would this be?

nathanblyth300 Hi again..Also hope for this pair at 1/200 scale if possible?

nathanblyth300 Hi. Any chance of this pair done @ 1/200 scale?

nathanblyth300 Hi, These look worthwhile, and I would be interested in purchasing a reduced set of 2 of these 60cal Nendo Shiki guns. (Yamato only had 2x of these types of guns) Are you able to list just a pair - Im hoping to be able to afford more of the others :) Cheers